H3c-technologies H3C WX6000 Series Access Controllers Manuale Utente Scaricare il pdf (Pagina 84)

Step2 To improve the upgrading speed, first modify the serial interface baud rate. For more information, see

“

Modifying serial communication parameters”

Step3 Select 2 in the serial interface submenu. The following prompt appears:

Please Start To Transfer File, Press <Ctrl+C> To Exit.

Waiting ...CCCCCCCCCC

Step4 Select and send the application file in HyperTerminal. The procedure for upgrading an application file

is the same as upgrading the BootWare. For more information, see “

Upgrading the BootWare through

a serial connection.”

NOTE:

The size of an application program is typically over 10 MB. Even at the baud rate of 115,200 bps, the

upgrade takes about 30 minutes. Therefore, you are recommended to up

rade an application pro

ram

through an Ethernet interface.

Upgrading applications through an Ethernet

interface

Select 3 in the BootWare main menu to enter the Ethernet interface submenu. For more information about

this submenu, see “

Ethernet interface submenu.”

Configuring Ethernet interface parameters

Before upgrading an application program through an Ethernet interface, configure the Ethernet interface

of the access controller, as follows.

Select 3 in the BootWare main menu to enter the Ethernet interface submenu. Then, select 5 to enter the

Ethernet interface configuration submenu:

============================<ETHERNET PARAMETER SET>============================

|Note: '.' = Clear field. |

| '-' = Go to previous field. |

| Ctrl+D = Quit. |

================================================================================

Protocol (FTP or TFTP) :tftp

Load File Name :wx6103.bin

Target File Name :wx6103.bin

Server IP Address :192.168.0.179

Local IP Address :192.168.0.1

Gateway IP Address :192.168.0.10

NOTE:

• When configuring a parameter, you can enter a new value directly, or press Enter to accept the defaul

value that follows a colon. Type . to clear the current input, - to return to the previous parameter field, and

Ctrl+D to quit from the parameter configuration interface.

• The WX6103 access controller supports only the 10/100/1000Base-TX out-of-band management

Ethernet interface for application upgrade.

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 90

Commenti su questo manuale

Nessun commento

H3c-technologies H3C WX6000 Series Access Controllers Manuale Utente Pagina 84

Commenti su questo manuale

Prodotti e manuali riguardandi Router H3c-technologies H3C WX6000 Series Access Controllers